Unofficial Inochi2D Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Tracking ======
**:!: You need to refresh to start the tracking :!:**
\\
\\
You can use the **Tracking** panel to see the list of parameters that the **puppet** was rigged with. By default, for each parameter you will see a widget that will let you select either a specific parameter from the currently connected **tracking sources**. You can either pick a specific **parameter** of one of the **bones** or the name of a **blendshape** to asociate the **parameter** to it. 
\\
\\
Be aware that the software won't try to detect which **bones** or **blendshapes** are available from connected **tracking sources** until you press the "**Refresh**" button in the **Tracking** panel. Also, there are many things that can get configured for a specific **parameter**. 
\\
\\
You can set which [[en:software:session:blendshape|blendshapes]] data will feed the parameter you have on your model.\\
\\
Before refresh button:\\
{{:en:software:session:inochi_session_tracking_no_data.png?nolink&200|Ada chibi without refresh}}
\\
\\
After ''refresh'' button, shows blendshapes. Now you can assign to your parameter.\\
{{:en:software:session:inochi_session_tracking_select.png?nolink&200|Ada chibi with refresh}}
\\
\\
When rigged, **puppet** **parameters** are usually set up so that they deform the puppet by a specific amount, usually between -1 and 1, or 0 and 1, but this doesn't always align with the input **bone** or **blendshape** data values. **Bone** position values and **blendshapes** usually can come in values between -inf and inf, but some of them only move between 0 and 1, while **bone** rotation values usually come in angle degrees (-180 and 180). 
\\
\\
To make the **tracking** data match with **parameter** values, the **Tracking In** and **Tracking Out** intervals are used. For the context of a specific parameter, the **tracking data** will be clamped to the **Tracking In** range, and it will be transformed to the values of the **Tracking Out** range, which are the ones used by the **puppet parameter**. You can see how these behave by looking at the yellow bars. You can also press the **Inverse** checkbox to flip the input data.
\\
\\
If you want to learn about Blendshapes and Bones, you can read more in the [[en:concept:start#bones_and_blendshapes|concept section]]
\\
\\
===== Examples =====
  * [[en:concept:pitch-roll-yaw|Pitch, Roll, Yaw]]
Unofficial Inochi2D Wiki

User Tools

Site Tools

Page Tools
